How To Change Oil On 2018 Kia Sorento

This oil alter tutorial was written to assist Kia owners with four-cylinder engines (Theta Two)—installed on many models, including Kia Rondo, Forte, Optima, Sportage, Sorento.

Requirements

• Warm up the engine for two to three minutes, and then turn information technology off. Information technology volition help with the suspended contaminations remix with the oil and bleed out with the old oil.
• Park the car on level basis.

What you will need

• 5W-xxx Engine Oil
  • Most commonly used
  • Total synthetic recommended
• Oil Filter
• 10mm, 17mm socket
• Torque wrench
• Oil filter pliers

Instructions

Open Hood

Start by ensuring that the emergency brakes have been set. Adjacent, locate the hood release establish in the interior of the car. Pull the hood release until y'all hear the hood pop up. Movement to the front of the vehicle and release the latch, then lift the hood.

Enhance vehicle

Using ramps makes irresolute the oil a much easier job and safer. If y'all plan on changing the oil regularly, you may want to consider investing in a fix of ramps. Jack up the forepart of the Kia using the jack that came with your car or an aluminum jack.

Secure Vehicle

Secure the vehicle with jack stands. Block the rear wheels.

Remove Bleed Plug & Drain Oil

The early Kias had an access pigsty where you could drain the oil and remove the filter. Specific Kia models don't have access holes, and so you volition need to remove the 10 mm bolts and pull down the skid panel to remove the oil filter and drain plug.

Lookout man the following video on how to remove the engine skid plate from a 2016 Kia Optima.

Loosen oil drain bolt

Locate the drain plug and remove the bolt. Use a 17 mm socket to remove this commodities by turning information technology counterclockwise. Once you suspension the bolt loose, you can use your hands to remove the commodities. Make certain to have the oil pan under the oil drain hole.

Remove and supervene upon the oil filter.

Locate the oil filter. In the following picture show, the oil filter stands out every bit it is cherry. The filter tin can be removed by twisting it counterclockwise. Use oil filter pliers to remove the old oil filter. Oil may still be in the filter, so be careful equally you remove the sometime filter to avert spilling oil on your hands.

Clean the surface where the oil filter will be installed.

Oil filter gasket

Utilize engine oil to the gasket on the new oil filter.

Screw the new oil filter in and tighten information technology by hand. If you prefer to utilise a torque wrench, tighten the filter to 11.5 ft-lb.

Add Engine Oil

Remove the oil filler cap on top of the engine. The oil filter cap should exist labeled and usually has the recommended oil type stamped on information technology. Remove the cap by unscrewing it counterclockwise. Insert a funnel into the oil filler hole.

Slowly pour the oil into the engine. Add together the required quarts as indicated in your owner's manual. One time you add the recommended amount of engine oil, reinstall the filler cap.

Bank check Engine Oil Level

Now nosotros demand to get-go the engine. Before you practice that, you lot should e'er cheque the engine oil level. Make sure the oil is below the FULL mark but in a higher place the Low.

Reset Oil Service Interval

Once you make certain the oil level is right, you can at present start the engine. Don't forget to reset the oil service reminder. In your Kia dashboard menu, look for the Distance to Service reminder.

The following are instructions on how to reset the Distance Reminder on Kia Optima. These instructions may vary on different Kia models.

1. Printing and hold the RESET button until the instrument cluster displays Engine Oil Service Reminder
2. Whorl downwards using the TRIP push button and select the Maintenace menu.
3. Select an item. Press the RESET button again.
4. Select the maintenance schedule. Note that this will depend on the oil and filter that you lot used. If you used conventional oil, yous would demand to change your oil in 3000 miles. Some constructed oils protect upward to 15,000 miles.

Notes

• Be conscientious when draining the oil. If the engine hasn't cooled downwards, the oil may be hot and cause burning. Allow at least five minutes for the one-time oil to drain. If time allows, let the oil drain for at least fifteen minutes or more than.
• Make clean the drain plug and the oil bolt using a clean, dry out cloth. Reinstall the drain bolt using your hand first. This will ensure that the bolt starts to get smoothly and no threads get damaged. If y'all have a new washer for the bleed bolt, make sure to install it.
• Tighten the oil drain plug past mitt until it stops. Then tighten the commodities to 25 ft-lbs.

Applications

Follow the instructions to larn how easy it is to change the engine oil on Kia models.

Theta/Theta-Ii Engine - ii.0L (G4KA, G4KD, G4KF, G4KH)

• Kia Rondo (2007-)

• Kia Forte 2.0 (2009-2013)

• Kia Optima GDI 2.0 Turbocharged (2011-)

• Kia Sportage GDI 2.0 Turbocharged (2011-)

• Kia Sorento GDI 2.0 Turbocharged (2016-)

Theta/Theta-Ii Engine - 2.4L (2359cc) (G4KC, G4KE, G4KG, G4KJ)

• Kia Optima (2006-2010)

• Kia Optima GDI (2011-)

• Kia Rondo (2007-)

• Kia Cadenza GDI (2011-)

• Kia Sportage (2011-)

• Kia Sorento (2011-)

• Kia Forte (2010-2013)

Source: https://www.youcanic.com/wiki/kia-engine-oil-change

Posted by: jimenezressigirly1956.blogspot.com

Share this post